LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> RAV4 LE, AWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System (2AR-FE) (Service Information) (Except Hybrid) >> Heated Oxygen Sensor >> Removal [12/2012 - ] >> Procedure

Removal [12/2012 - ]: Procedure

  1. REMOVE FRONT EXHAUST PIPE SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 2

  2. REMOVE FRONT NO. 2 EXHAUST PIPE SUB-ASSEMBLY 
    1. Remove the 2 bolts and No. 2 exhaust pipe sub-assembly from the center exhaust pipe assembly.
      GTY362793Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the gasket from the front No. 2 exhaust pipe sub-assembly.
  3. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) 
    1. Disconnect the heated oxygen sensor connector.
    2. Using SST, remove the heated oxygen sensor from the front No. 2 exhaust pipe sub-assembly.
      GTY384377Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09224-00010 
scientia non olet · About LEMON Manuals