Installation [12/2012 - ]: Procedure

1. Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

   Adhesive

   TOYOTA Genuine Adhesive 1344, Three Bond 1344 or equivalent.

   NOTE:

   Do not let adhesive adhere to the oil hole.

2. Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

   Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

   NOTE:

   Do not start the engine within 1 hour of installation.

3. Connect the engine oil pressure switch connector.

See step  5