Removal [12/2012 - ]: Procedure
- PRECAUTION NOTE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Refer to PRECAUTION [12/2012 - ]
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [12/2012 - 10/2015] , or refer to INITIALIZATION [10/2015 - 08/2016] , or refer to INITIALIZATION [08/2016 - ]
- REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
Refer to PROCEDURE - Step 3
- REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL
Refer to PROCEDURE - Step 4
- REMOVE FRONT DOOR ASSIST GRIP COVER LH
Refer to PROCEDURE - Step 9
- REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
Refer to PROCEDURE - Step 10
- REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 11
- REMOVE SEAT MEMORY SWITCH
- Detach the 4 claws to remove the seat memory switch.