DRL Relay Circuit [09/2013 - ]: Procedure

1. Using the Techstream, perform the Active Test. Refer to DATA LIST / ACTIVE TEST [09/2013 - ] .
   MAIN BODY
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Daytime Running Light	Daytime running light	ON/OFF	-

   OK

   Daytime running lights come on.

NG → See step   2 

OK → REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) 

1. Remove the daytime running light relay from the No. 2 motor compartment room relay block and junction block.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   3 - 5	Battery voltage applied between terminals 1 and 2	Below 1 Ω
   3 - 5	Battery voltage not applied between terminals 1 and 2	10 kΩ or higher

NG → REPLACE DAYTIME RUNNING LIGHT RELAY (DRL NO. 2) 

OK: Go to next step 

1. Remove the daytime running light relay from the No. 2 motor compartment room relay block and junction block.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   Daytime running light relay terminal 5 - Body ground	Headlight dimmer switch in DRL OFF position	11 to 14 V
   Daytime running light relay terminal 1 - Body ground
   Daytime running light relay terminal 5 - Body ground	Headlight dimmer switch in head position	Below 1 V
   Daytime running light relay terminal 1 - Body ground

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Daytime Running Light Relay)

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Remove the daytime running light relay from the No. 2 motor compartment room relay block and junction block.
2. Disconnect the E16 main body ECU connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   Daytime running light relay terminal 2 - E16-3 (DIM)	Always	Below 1 Ω
   E16-3 (DIM) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   5