Installation [10/2013 - ]

INSTALL COMBINATION METER ASSEMBLY
1. Engage the clip.
  
  Fig 1: Locating Combination Meter Assembly, Connector, Clamp, Screws & Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the combination meter assembly with the 3 screws.
3. Engage the clamp.
4. Connect the connector.
INSTALL NO. 1 HEATER TO REGISTER DUCT . Refer to INSTALLATION [10/2013 - ] - Step 10
INSTALL UPPER INSTRUMENT PANEL ASSEMBLY
1. Install the upper instrument panel assembly. Refer to INSTALLATION [10/2013 - ] .