Removal [12/2013 - ]

PRECAUTION
NOTE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work. Refer to PRECAUTION [12/2013 - ] .
REMOVE FRONT FLOOR COVER RH . Refer to REMOVAL [12/2013 - ] - Step 3
DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION [12/2013 - ] .
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY . Refer to REMOVAL [12/2013 - ] - Step 4
REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY . Refer to REMOVAL [12/2013 - ] - Step 5
REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH . Refer to REMOVAL [12/2013 - ] - Step 6
REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY . Refer to REMOVAL [12/2013 - ] - Step 7
REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY . Refer to REMOVAL [12/2013 - ] - Step 8
REMOVE COMBINATION METER ASSEMBLY
1. Remove the 2 screws.
  
  Fig 1: 2 Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disengage the 3 clips as shown in the illustration.
  
  Fig 2: 3 Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Disconnect the 2 connectors.
  
  Fig 3: 2 Connectors, Clamp & Combination Meter Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Disengage the clamp and remove the combination meter assembly.