LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 96 (SFI System [2GR-FXE] - Diagnostic Codes - (Hybrid) (1 Of 3)) >> SFI System >> DTC P0441: Evaporative Emission Control System Incorrect Purge Flow [02/2014 - 11/2016] >> Procedure

DTC P0441: Evaporative Emission Control System Incorrect Purge Flow [02/2014 - 11/2016]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO P0441) 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
    5. Read the DTCs.

      Powertrain > Engine and ECT > Trouble Codes 

      Result

      Result Proceed to
      DTC P0441 is output A
      DTC P0441 and other DTCs are output B

      HINT: 

      If any DTCs other than DTC P0441 are output, troubleshoot those DTCs first.

    Result:  1

    A 

    GO TO EVAP SYSTEM. Refer to  EVAP System [02/2014 - 11/2016] 

    Result:  2

    B 

    GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [02/2014 - 08/2014]  Refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2014 - 11/2015]  Refer to  DIAGNOSTIC TROUBLE CODE CHART [11/2015 - 11/2016] 

scientia non olet · About LEMON Manuals