LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, FWD >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Parking Brake (Service Information) (Except Hybrid) >> Parking Brake Switch >> Inspection [12/2013 - ] >> Procedure

Inspection [12/2013 - ]: Procedure

  1. INSPECT PARKING BRAKE SWITCH ASSEMBLY 
    1. Measure the resistance between the connector terminal and the nut inside the parking brake switch assembly.
      GTY441614Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Terminal
      *b Nut
      *c ON
      *d OFF
      STANDARD RESISTANCE

      Tester Connection Condition Specified Condition
      Terminal - Nut On (When shaft is not pressed) Below 1 Ω
      Terminal - Nut Off (When shaft is pressed) 10 kΩ or higher

      If the value is not as specified, replace the parking brake switch assembly.

scientia non olet · About LEMON Manuals