Installation [12/2013 - ]: Procedure

INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY

Install the parking brake control pedal assembly to the body with the 3 nuts.
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
Connect the parking brake switch connector.
Insert the No. 1 parking brake cable assembly toward the outside of the cabin.

Engage the clamp.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Temporarily install the lock nut.

HINT:

After adjusting parking brake pedal travel, tighten the lock nut.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Lock Nut
*2	No. 1 Wire Adjusting Nut

INSTALL WIRE HARNESS CLAMP BRACKET
Refer to PROCEDURE - Step 14 , or refer to PROCEDURE - Step 14
INSTALL INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY WITH MAIN BODY ECU
Refer to PROCEDURE - Step 2

INSTALL PARKING BRAKE EQUALIZER

Install the parking brake equalizer to the No. 1 parking brake cable assembly as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Slide the rubber boot back as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Groove

NOTE:

Securely fit the protrusion on the rubber boot into the No. 1 parking brake cable assembly groove.

CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
1. Connect the No. 3 parking brake cable assembly to the parking brake equalizer.
CONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY
HINT:

Perform the same procedure as for the No. 3 parking brake cable assembly.
INSPECT PARKING BRAKE PEDAL TRAVEL
Refer to PROCEDURE - Step 1
ADJUST PARKING BRAKE PEDAL TRAVEL
Refer to PROCEDURE - Step 2
INSTALL REAR ENGINE SERVICE COVER ASSEMBLY
1. Install the rear engine service cover assembly to the body with the 2 bolts.

INSTALL FRONT CENTER FLOOR COVER

Engage the 4 clips to install the front center floor cover.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

	Nut
	Screw

INSTALL FRONT FLOOR COVER LH

Engage the 2 clips (B) to install the front floor cover LH.

	Bolt
	Screw

INSTALL FRONT NO. 3 FLOOR SILENCER
1. Install the front No. 3 floor silencer to the original position.

INSTALL FRONT FLOOR FOOTREST

Engage the 2 clips to install the front floor footrest.

INSTALL REAR NO. 1 AIR DUCT
Refer to PROCEDURE - Step 11 , or refer to PROCEDURE - Step 11
INSTALL REAR NO. 2 AIR DUCT
Refer to PROCEDURE - Step 12 , or refer to PROCEDURE - Step 12
INSTALL CONSOLE BOX INSERT
Refer to PROCEDURE - Step 18
INSTALL FRONT FLOOR CARPET ASSEMBLY
1. Engage the 3 floor carpet hooks to install the front floor carpet assembly.
CONNECT FRONT SEAT OUTER BELT ASSEMBLY LH
Refer to PROCEDURE - Step 5 , or refer to PROCEDURE - Step 5
INSTALL LOWER CENTER PILLAR GARNISH LH
Refer to PROCEDURE - Step 48 , or refer to PROCEDURE - Step 49 , or refer to PROCEDURE - Step 48
INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
Refer to PROCEDURE - Step 49 , or refer to PROCEDURE - Step 50 , or refer to PROCEDURE - Step 49
INSTALL REAR DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 50 , or refer to PROCEDURE - Step 51 , or refer to PROCEDURE - Step 50
INSTALL REAR OUTER SEAT TRACK BRACKET COVER LH
Refer to PROCEDURE - Step 4
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Refer to PROCEDURE - Step 53 , or refer to PROCEDURE - Step 54 , or refer to PROCEDURE - Step 53
INSTALL CONSOLE BOX ASSEMBLY
Refer to INSTALLATION [12/2013 - ]
INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to INSTALLATION [12/2013 - ]
INSTALL FRONT SEAT ASSEMBLY LH
for Manual Seat: Refer to INSTALLATION [12/2013 - ]

for Power Seat: Refer to INSTALLATION [12/2013 - ]
INSPECT BRAKE WARNING LIGHT
Refer to PROCEDURE - Step 3