LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Horns >> Horn System (Service Information) (Except Hybrid) >> Relay >> On-Vehicle Inspection [12/2013 - ] >> Procedure

On-Vehicle Inspection [12/2013 - ]: Procedure

  1. INSPECT HORN RELAY 
    1. Remove the HORN relay.
      GTY427152Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (HORN Relay)
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
      3 - 5 Battery voltage applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the HORN relay.

scientia non olet · About LEMON Manuals