DTC C1A10: Front Radar Sensor [11/2016 - ]: Procedure

1. Replace the millimeter wave radar sensor assembly.

   Refer to REMOVAL [11/2016 - ]

2. Adjust the millimeter wave radar sensor assembly.

   Refer to ADJUSTMENT [11/2016 - ]

Result: 

NEXT 

See step  2

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [11/2016 - ]

   Chassis > LKA/LDA > Clear DTCs 

2. Perform the following procedure.

   HINT: 

   If the following procedure is not performed, the previously output DTC cannot be detected.

   1. Turn the ignition switch to ON and wait 7 seconds or more.
3. Check for DTCs.

   Refer to DTC CHECK / CLEAR [11/2016 - ]

   Chassis > LKA/LDA > Trouble Codes 

   Result	Proceed to
   DTC C1A10 is not output	A
   DTC C1A10 is output	B

Result: 

A 

END (MILLIMETER WAVE RADAR SENSOR ASSEMBLY WAS DEFECTIVE) 

Result: 

B 

REPLACE FORWARD RECOGNITION CAMERA. 

Refer to  COMPONENTS [11/2016 - ]