Installation [11/2015 - 11/2016]: Procedure

INSTALL REAR NO. 2 SEAT OUTER BELT ASSEMBLY
1. Temporarily install the rear No. 2 seat outer belt assembly with the 2 bolts.
  
  Fig 1: Tightening Sequence Of Rear No. 2 Seat Outer Belt Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Fully tighten the bolt (A) first, then the bolt (B).
  Bolt (A)
  
  Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
  
  Bolt (B)
  
  Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
3. Connect the shoulder anchor of the rear No. 2 seat outer belt assembly with the bolt.
  Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
INSTALL INNER ROOF SIDE GARNISH ASSEMBLY
Refer to PROCEDURE - Step 22
INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)
Refer to PROCEDURE - Step 24
INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)
Refer to PROCEDURE - Step 35
INSTALL ROPE HOOK
Refer to PROCEDURE - Step 25
INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Refer to PROCEDURE - Step 26
INSTALL DECK TRIM POCKET COVER
Refer to PROCEDURE - Step 27
INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for RH Side)
Refer to PROCEDURE - Step 2
INSTALL SIDE TRIM COVER RH (w/o Rear Automatic Air Conditioning System)
for RH Side:

Refer to PROCEDURE - Step 40
INSTALL COOLER (NO. 2 ROOM TEMP. SENSOR) THERMISTOR (w/ Rear Automatic Air Conditioning System)
for RH Side:

Refer to PROCEDURE - Step 1

CONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY

Connect the floor anchor of the rear No. 2 seat outer belt assembly with the bolt.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Protruding Part

Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)

NOTE:

Do not allow the anchor part of the rear No. 2 seat outer belt assembly to overlap the protruding part of the floor panel.