LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Air Conditioning System (Service Information) (Except Hybrid) (2 Of 2) >> COMPRESSOR (for 1AR-FE) >> Removal [12/2013 - ] >> Procedure

Removal [12/2013 - ]: Procedure

  1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM 

    Refer to PROCEDURE - Step 1

  2. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 8 , or refer to PROCEDURE - Step 8

  3. REMOVE V-RIBBED BELT 

    Refer to REMOVAL [12/2013 - ]

  4. DISCONNECT SUCTION HOSE SUB-ASSEMBLY 
    1. Remove the bolt and disconnect the suction hose sub-assembly from the compressor assembly with pulley.
      GTY449864Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the O-ring from the suction hose sub-assembly.
      NOTE:

      Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

  5. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY 
    1. Remove the bolt and disconnect the discharge hose sub-assembly from the compressor assembly with pulley.
      GTY449859Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the O-ring from the discharge hose sub-assembly.
      NOTE:

      Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

  6. REMOVE COMPRESSOR ASSEMBLY WITH PULLEY 
    1. Disconnect the connector.
      GTY456046Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt.
    3. Remove the 2 bolts and 2 nuts.
      GTY437282Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Bolt
      Nut
    4. Using an E8 "TORX" socket wrench, remove the 2 stud bolts.
      GTY449845Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Remove the compressor assembly with pulley.
scientia non olet · About LEMON Manuals