LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical (1AR-FE) (Service Information) (Except Hybrid) (1 Of 2)) >> Drive Belt >> On-Vehicle Inspection [12/2013 - ] >> Procedure

On-Vehicle Inspection [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT V-RIBBED BELT 
    1. Check the V-ribbed belt for wear, cracks or other signs of damage.
      GTY427602Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Incorrect

      If any of the following defects is found, replace the V-ribbed belt.

      • The V-ribbed belt is cracked.
      • The V-ribbed belt is worn out to the extent that the cords are exposed.
      • The V-ribbed belt has chunks missing from the ribs.
    2. Check that the V-ribbed belt fits properly in the ribbed grooves.

      HINT: 

      Make sure to check by hand that the V-ribbed belt has not slipped out of the groove on the bottom of the pulley. If it has slipped out, replace the V-ribbed belt. Install a new V-ribbed belt correctly.

      GTY434019Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Correct
      *b Incorrect
scientia non olet · About LEMON Manuals