Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
THE FOLLOWING ITEMS ARE COMMON TO ALL CONDITIONS BELOW.
| The monitor will run whenever this DTC is not present. (Not circuit malfunction) |
P0712, P0713 (ATF temperature sensor circuit (TFT sensor)) P0115, P0117, P0118 (ECT sensor circuit) P0717, P07BF, P07C0 (Turbine speed sensor circuit) P0793, P07C5, P07C6 (Intermediate shaft speed sensor circuit) P0748 (Shift solenoid valve SL1 circuit) P0778 (Shift solenoid valve SL2 circuit) P0798 (Shift solenoid valve SL3 circuit) P2810 (Shift solenoid valve SL4 circuit) P2759 (Shift solenoid valve SLU circuit) P2769, P2770 (Shift solenoid valve SL circuit) P0327, P0328, (KCS sensor circuit) P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P060A, P060B, P060D, P060E, P0657, P1607, P2102, P2103, P2111, P2112, P2118, P2119, P2135 ((ETCS) Electronic throttle control system) U0100 (CAN communication system) |
| ECT (Engine coolant temperature) | 40°C (104°F) or more |
| Spark advance from Max. retard timing by KCS control | 0°CA or more |
| Transmission range | "D" |
| TFT (Transmission fluid temperature) | -10°C (14°F) or more |
| TFT (Transmission fluid temperature) sensor circuit | No circuit malfunction |
| ECT (Engine coolant temperature) sensor circuit | No circuit malfunction |
| Turbine speed sensor circuit | No circuit malfunction |
| Intermediate shaft speed sensor circuit | No circuit malfunction |
| Shift solenoid valve SL1 circuit | No circuit malfunction |
| Shift solenoid valve SL2 circuit | No circuit malfunction |
| Shift solenoid valve SL3 circuit | No circuit malfunction |
| Shift solenoid valve SL4 circuit | No circuit malfunction |
| Shift solenoid valve SLU circuit | No circuit malfunction |
| Shift solenoid valve SL circuit | No circuit malfunction |
| (KCS) Knock control sensor circuit | No circuit malfunction |
| (ETCS) Electronic throttle control system | Not system down |
| CAN communication system | Not system down |
| Engine | Starting |
| ECM selected gear | Not 1st |
| Vehicle speed | 15.5 mph (25 km/h) or more |
| Turbine speed/Output speed (NT/NO) with 1st | 3.232 to 7.556 |
| Turbine speed/Output speed (NT/NO) with 2nd | 1.860 to 2.289 |
| Turbine speed/Output speed (NT/NO) with 3rd | 1.369 to 1.613 |
| Turbine speed/Output speed (NT/NO) with 4th | 0.976 to 1.113 |
| Turbine speed/Output speed (NT/NO) with 5th | 0.690 to 0.818 |
| Turbine speed/Output speed (NT/NO) with 6th | 0.556 to 0.680 |
OFF MALFUNCTION:
| ECM lock-up command | ON (SL ON, SLU pressure: 513 kPa (5.2 kgf/cm2 , 74 psi) or more) |
| Duration time from lock-up on command | 3 sec. or more |