Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL:
| The monitor will run whenever this DTC is not present | None |
| Solenoid current cut status | Not cut |
| Ignition switch | ON |
| Starter | OFF |
MALFUNCTION (A):
| Battery voltage | 12 V or more |
| Target current | 1 A |
MALFUNCTION (B):
| Battery voltage | 10 V or more and less than 12 V |
| Target current | 0.75 A |
MALFUNCTION (C):
| Battery voltage | 8 V or more |
| Target current | 0.25 A or more |
MALFUNCTION (D):
| Battery voltage | 11 V or more |
| Target current | 0.2 A or more |
MALFUNCTION (E):
| Battery voltage | 11 V or more |
| Target current | 0.1 A or more |
| Target voltage - Last target voltage | Less than 0.02 V |