Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL:
| The monitor will run whenever this DTC is not present. (Not circuit malfunction) |
P0712, P0713 (ATF temperature sensor circuit (TFT sensor)) P0115, P0117, P0118 (ECT sensor circuit) P0717, P07BF, P07C0 (Turbine speed sensor circuit) P0793, P07C5, P07C6 (Intermediate shaft speed sensor circuit) P0748 (Shift solenoid valve SL1 circuit) P0778 (Shift solenoid valve SL2 circuit) P0798 (Shift solenoid valve SL3 circuit) P2810 (Shift solenoid valve SL4 circuit) P0327, P0328, (KCS sensor circuit) P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P060A, P060B, P060D, P060E, P0657, P1607, P2102, P2103, P2111, P2112, P2118, P2119, P2135 ((ETCS) Electronic throttle control system) U0100 (CAN communication system) |
| Transmission range | "D" |
| TFT (Transmission fluid temperature) | -10°C (14°F) or more |
| TFT (Transmission fluid temperature) sensor circuit | No circuit malfunction |
| ECT (Engine coolant temperature) sensor circuit | No circuit malfunction |
| Turbine speed sensor circuit | No circuit malfunction |
| Intermediate shaft speed sensor circuit | No circuit malfunction |
| Shift solenoid valve SL1 circuit | No circuit malfunction |
| Shift solenoid valve SL2 circuit | No circuit malfunction |
| Shift solenoid valve SL3 circuit | No circuit malfunction |
| Shift solenoid valve SL4 circuit | No circuit malfunction |
| (KCS) Knock control sensor circuit | No circuit malfunction |
| (ETCS) Electronic throttle control system | Not system down |
| CAN communication system | Not system down |
| Engine | Starting |
OFF MALFUNCTION (A):
| ECM selected gear | 2nd |
| Throttle valve opening angle | 3% or more |
| ECM indicated pressure value of SL1 | 1, 200 kPa |
| ECM indicated pressure value of SL2 | 0 kPa |
| ECM indicated pressure value of SL3 | 1, 200 kPa |
OFF MALFUNCTION (B):
| ECM selected gear | 6th |
| Throttle valve opening angle | 3% or more |
| ECM indicated pressure value of SL1 | 0 kPa |
| ECM indicated pressure value of SL2 | 1, 200 kPa |
| ECM indicated pressure value of SL3 | 1, 200 kPa |
OFF MALFUNCTION (C):
| ECM selected gear | 2nd |
| Throttle valve opening angle: | |
| (When condition "D" is not detected) | 6.5% or more at engine speed 2, 000 rpm (condition varies with engine speed) |
| (When condition "D" is detected) | 3.0% or more at engine speed 750 rpm (condition varies with output speed) |
| ECT (engine coolant temperature) | 40°C (104°F) or more |
OFF MALFUNCTION (D):
| Throttle valve opening angle | 3.0% or more at engine speed 750 rpm (condition varies with output speed) |
ON MALFUNCTION:
| ECM selected gear | 1st |
| Vehicle speed | 1.2 mph (2 km/h) to 24.9 mph (40 km/h) |
| Engine speed - Turbine speed | 50 rpm or more |
| ECT (engine coolant temperature) | 40°C (104°F) or more |