System Description
WARNING: This page is about a different variant/trim than selected.
The ECM uses the vehicle speed signal and signals from the transmission speed sensors (NC, NT) to detect the actual gear (1st, 2nd, 3rd, 4th, 5th or 6th gear).
The ECM compares the actual gear with the shift schedule in the ECM memory to detect mechanical problems of the shift solenoid valves and valve body.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0796 | Pressure Control Solenoid "C" Performance (Shift Solenoid Valve SL3) | The engine revs freely when 2nd or 6th gear is commanded (2-trip detection logic). When the following is detected twice (2-trip detection logic):
|
|
Comes on | DTC stored |