DTC P0712: Transmission Fluid Temperature Sensor "A" Circuit Low Input; DTC P0713: Transmission Fluid Temperature Sensor "A" Circuit High Input [12/2013 - 10/2017]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK HARNESS AND CONNECTOR (ATF TEMPERATURE SENSOR CIRCUIT)
- Disconnect the ECM connector.
*a Front view of wire harness connector
(to ECM) - Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition C1-120 (THO1) - C1-119 (ETHO) Always 79 Ω to 156 kΩ C1-120 (THO1) - Body ground and other terminals Always 10 kΩ or higher C1-119 (ETHO) - Body ground and other terminals Always 10 kΩ or higher Result
Proceed to OK NG
Result: 1
OK
REPLACE ECM. Refer to COMPONENTS [12/2013 - 11/2016] Refer to COMPONENTS [11/2016 - ]
Result: 2
NG
See step 2
- Disconnect the ECM connector.
- CHECK HARNESS AND CONNECTOR (ECM - WIRING HARNESS CONNECTOR)
- Disconnect the connector from the wiring harness connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition C1-120 (THO1) - C2-13 (OIL) Always Below 1 Ω C1-119 (ETHO) - C2-12 (E2) Always Below 1 Ω C1-120 (THO1) or C2-13 (OIL) - Body ground and other terminals Always 10 kΩ or higher C1-119 (ETHO) or C2-12 (E2) - Body ground and other terminals Always 10 kΩ or higher Result
Proceed to OK NG
Result: 2
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result: 1
OK
See step 3
- INSPECT TRANSMISSION WIRE (ATF TEMPERATURE SENSOR)
- Remove the wiring harness connector from the transaxle.
*a Component without harness connected
(Transmission Wire) - Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition A-17 (E2) - A-18 (THO1) Always 79 Ω to 156 kΩ A-17 (E2) - Body ground and other terminals Always 10 kΩ or higher A-18 (THO1) - Body ground and other terminals Always 10 kΩ or higher HINT:
If the resistance is out of the specified range with the ATF temperature shown in the table below, the driveability of the vehicle may decrease.
ATF Temperature Specified Condition 10°C (50°F) 5 to 8 kΩ 25°C (77°F) 2.5 to 4.5 kΩ 110°C (230°F) 0.22 to 0.28 kΩ Result
Proceed to OK NG
Result: 1
OK
REPLACE WIRING HARNESS CONNECTOR. Refer to COMPONENTS [12/2013 - 11/2016] Refer to COMPONENTS [11/2016 - ]
Result: 2
NG
REPLACE TRANSMISSION WIRE (ATF TEMPERATURE SENSOR). Refer to COMPONENTS [12/2013 - ]
- Remove the wiring harness connector from the transaxle.