DTC P0711: Transmission Fluid Temperature Sensor "A" Performance [12/2013 - 11/2015]: Description

WARNING: This page is about a different variant/trim than selected.

The Automatic Transmission Fluid (ATF) temperature sensor converts the fluid temperature into a resistance value for use by the ECM.

The ECM applies a voltage to the temperature sensor through terminal THO1 of the ECM.

The sensor resistance changes with the ATF temperature. As the temperature becomes higher, the sensor resistance decreases.

One terminal of the sensor is grounded so that the sensor resistance decreases and the voltage goes down as the temperature becomes higher.

The ECM calculates the fluid temperature based on the voltage signal.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area	MIL	Memory
P0711	Transmission Fluid Temperature Sensor "A" Performance	Either condition is met: (2-trip detection logic) (a) Certain monitor enabling conditions are met and the ATF temperature is below 20°C (68°F) (b) Certain monitor enabling conditions are met and the ATF temperature is 110°C (230°F) or higher	ATF temperature sensor	Comes on	DTC stored