Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
NOTE:
Perform the universal trip to clear permanent DTCs.
Refer to DTC CHECK / CLEAR [12/2013 - ]
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- DATA LIST NOTE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- Warm up the engine.
- Turn the ignition switch off.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Data List.
- According to the display on the Techstream, read the Data List.
Powertrain > Engine > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note Neutral Position SW Signal PNP switch status ON or OFF - ON: Shift lever in P or N
- OFF: Shift lever not in P or N
When the shift lever position displayed on the Techstream differs from the actual position, the adjustment of the park/neutral position switch or shift cable may be incorrect. Shift SW Status (P Range) PNP switch status ON or OFF - ON: Shift lever in P
- OFF: Shift lever not in P
When the shift lever position displayed on the Techstream differs from the actual position, the adjustment of the park/neutral position switch or shift cable may be incorrect. Shift SW Status (R Range) PNP switch status ON or OFF - ON: Shift lever in R
- OFF: Shift lever not in R
When the shift lever position displayed on the Techstream differs from the actual position, the adjustment of the park/neutral position switch or shift cable may be incorrect. Shift SW Status (N Range) PNP switch status ON or OFF - ON: Shift lever in N
- OFF: Shift lever not in N
When the shift lever position displayed on the Techstream differs from the actual position, the adjustment of the park/neutral position switch or shift cable may be incorrect. Sports Mode Selection SW Sport mode select switch status ON or OFF - ON: Shift lever in S, "+" or "-"
- OFF: Shift lever not in S, "+" or "-"
- Shift SW Status (D Range) PNP switch status ON or OFF - ON: Shift lever in D or S
- OFF: Shift lever not in D or S
When the shift lever position displayed on the Techstream differs from the actual position, the adjustment of the park/neutral position switch or shift cable may be incorrect. Powertrain > Engine > Data List
Tester Display Neutral Position SW Signal Shift SW Status (P Range) Shift SW Status (R Range) Shift SW Status (N Range) Sports Mode Selection SW Shift SW Status (D Range)