LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transmission (U760E) - Service Information (1 Of 2)) >> Transmission Wire >> Installation [11/2016 - ] >> Procedure

Installation [11/2016 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL TRANSMISSION WIRE 
    1. Install the transmission wire and lock plate to the transmission valve body assembly with the bolt.

      Torque: 10.8 N*m (110 kgf*cm, 8 ft.*lbf) 

    2. Coat the temperature sensor with ATF.
    3. Install the temperature sensor and lock plate to the transmission valve body assembly with the bolt.

      Torque: 10.8 N*m (110 kgf*cm, 8 ft.*lbf) 

    4. Engage the transmission wire clamp.
    5. Connect the 7 shift solenoid valve connectors.
    6. Connect the transmission revolution sensor connector.
  2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY 

    Refer to INSTALLATION [11/2016 - ] 

scientia non olet · About LEMON Manuals