DTC P0617: Starter Relay Circuit High [11/2016 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine and ECT / Data List / Primary / Starter Signal.

   Powertrain > Engine and ECT > Data List 

   Tester Display
   Starter Signal

5. Check the value displayed on the Techstream when the vehicle is driven at 20 km/h (12.43 mph) or more.
   WARNING:

   When performing the confirmation driving pattern, obey all speed limits and traffic laws.

   Condition	Starter Signal	Result
   Driving at 20 km/h (12.43 mph) or more	OFF	A
   	ON	B

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS. 

Refer to  CHECK FOR INTERMITTENT PROBLEMS [12/2013 - ] 

Result: 

B 

See step  2

1. Inspect the park/neutral position switch assembly.

   Refer to INSPECTION [12/2013 - ]

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY. 

Refer to  REMOVAL [12/2013 - ] 

Result: 

OK 

See step  3

1. Repair or replace harness or connector (park/neutral position switch assembly - ECM - ST relay).

Result: 

NEXT 

See step  4

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [11/2016 - ]

   Powertrain > Engine and ECT > Clear DTCs 

5. Turn the ignition switch off and wait for at least 30 seconds.
6. Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
7. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
8. Read the DTCs.

   Powertrain > Engine and ECT > Trouble Codes 

   Result	Proceed to
   DTC P0617 is output	A
   DTCs are not output	B

Result: 

A 

REPLACE ECM. 

Refer to  REMOVAL [12/2013 - ] 

Result: 

B 

END