DTC P0500: Vehicle Speed Sensor [11/2016 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON and turn the Techstream on.
3. Enter the following menus: Powertrain / Engine and ECT / Data List / Primary / Vehicle Speed.

   Powertrain > Engine and ECT > Data List 

   Tester Display
   Vehicle Speed

4. Drive the vehicle.
5. Read the value displayed on the Techstream.

   Result	Proceed to
   Values displayed on Techstream and speedometer display not equal	A
   Values displayed on Techstream and speedometer display equal	B

Result: 

B 

CHECK FOR INTERMITTENT PROBLEMS. 

Refer to  CHECK FOR INTERMITTENT PROBLEMS [12/2013 - ] 

Result: 

A 

See step  2

1. Disconnect the combination meter assembly connector.
2. Disconnect the ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F124-5 (+S) - A43-57 (SPD)	Always	Below 1 Ω

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  3

1. Check the circuits that send vehicle speed signals to this system in the combination meter system.

   Refer to Speed Signal Circuit [11/2016 - ]

Result: 

NEXT 

See step  4

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [11/2016 - ]

   Powertrain > Engine and ECT > Clear DTCs 

5. Turn the ignition switch off and wait for at least 30 seconds.
6. Start the engine.
7. Turn the Techstream on.
8. Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
9. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
10. Read the DTCs.

    Powertrain > Engine and ECT > Trouble Codes 

    HINT: 

    If no DTCs (no pending DTCs) are output to the Techstream, the repair has been successfully completed.

Result: 

NEXT 

END