LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Fuel System (2GR-FKS) (Service Information) (Except Hybrid)) >> Fuel Sender Gauge Assembly >> Installation [11/2016 - ] >> Procedure

Installation [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FUEL SENDER GAUGE ASSEMBLY 
    1. Engage the claw to install the fuel sender gauge assembly to the fuel suction tube with pump and gauge assembly.
      NOTE:

      Be careful not to bend the arm of the fuel sender gauge assembly.

    2. Connect the fuel sender gauge assembly connector.
    3. Engage the clamp to connect the wire harness.
      NOTE:
      • Make sure that the wire harness has a moderate amount of slack.
      • Do not damage the wire harness.
  2. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY 

    Refer to INSTALLATION [11/2016 - ] 

scientia non olet · About LEMON Manuals