Inspection [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT FUEL SENDER GAUGE ASSEMBLY

Check that the float moves smoothly between F and E.

Check the fuel sender gauge assembly voltage.

Apply 5 V between terminals 2 and 3.

NOTE:

Be careful when connecting the leads, as the fuel sender gauge assembly may be damaged if the leads are connected to the wrong terminals.
Do not apply more than 6 V to terminals 2 or 3.

HINT:

If a stable power supply is not available, connect 4 nickel-metal hydride batteries (1.2 V each) or equivalent in series.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Component without harness connected (Fuel Sender Gauge Assembly)
*b	Voltage Applied between Terminals

Measure the voltage according to the value(s) in the table below.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Component without harness connected (Fuel Sender Gauge Assembly)

Standard Voltage

Tester Connection	Float Level	Specified Condition
1 - 2	F	4.255 to 4.605 V*
	Between F and E	0.345 to 4.605 V* (Gradually changes)
	E	0.345 to 0.695 V*

*: The output voltage changes depending on the voltage applied to the terminals.

Output voltage (F) = (0.851 x Voltage applied to terminals) to (0.921 x Voltage applied to terminals)

Output voltage (E) = (0.069 x Voltage applied to terminals) to (0.139 x Voltage applied to terminals)

If the result is not as specified, replace the fuel sender gauge assembly.