Reassembly [11/2016 - ]: Procedure

HINT: 

Perform "Inspection After Repair" after replacing the fuel pump.

Refer to INITIALIZATION [11/2016 - ]

1. Apply a light coat of gasoline to a new O-ring. Then install the O-ring and fuel pump spacer to the fuel pump.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	O-ring
   *2	Fuel Pump Spacer

2. Install the fuel pump to the fuel pump filter.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Engage the 3 claws to install the fuel pump filter with the fuel pump to the fuel filter.
   NOTE:

   • Make sure that the O-ring is not cut or pinched during the installation.
   • Do not damage the fuel filter.
   • Securely engage the claws.
2. Connect the fuel pump harness connector to install the fuel pump harness to the fuel pump.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. Engage the claw to connect the fuel pump harness to the fuel pump filter.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   • Securely engage the claw.
   • Make sure that there is no foreign matter between the fuel pump and the ground terminal of the fuel pump harness.
   • Make sure that the ground terminal of the fuel pump harness is securely connected to the fuel pump body.
4. Check the connection state of the fuel pump harness.
   1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection	Condition	Specified Condition
      Fuel pump body - Ground terminal of the fuel pump harness	Always	Below 1 Ω

      If the result is not as specified, reconnect the fuel pump harness to the fuel pump filter so that the ground terminal of the fuel pump harness is securely connected to the fuel pump body.

1. Engage the 2 claws to install the fuel filter to the No. 1 fuel sub-tank.
   NOTE:

   • Do not apply excessive force to the tube or No. 1 fuel suction support.
   • Securely engage the claws.
2. Install the spring to the fuel suction plate shaft and then install the fuel suction plate sub-assembly to the No. 1 fuel sub-tank.
3. Install a new E-ring to the fuel suction plate shaft.
4. Engage the clamp and claw, and connect the fuel pump filter hose while aligning it with the installation position of the No. 1 fuel sub-tank.
   NOTE:

   Securely engage the clamp and claw.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

5. Connect the 2 fuel pump harness connectors.
   NOTE:

   Make sure that the fuel pump harness connectors are connected securely.

6. Engage the clamp to connect the fuel pump harness to the fuel suction plate sub-assembly as shown in the illustration.
   NOTE:

   Make sure that the fuel pump harness has a moderate amount of slack.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Black
   *b	Red
   *c	Blue
   *d	Yellow

See step  1