On-Vehicle Inspection [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

FUEL PUMP ASSEMBLY OPERATION

Check fuel pressure.

Connect the Techstream to the DLC3.
Start the engine.
Turn the Techstream on.

Enter the following menus: Powertrain / Engine / Active Test / Control the Target Fuel Pressure Offset.

Powertrain > Engine > Active Test

Active Test Display
Control the Target Fuel Pressure Offset

Data List Display
Fuel Pressure (High)

Select the Data List item: Fuel Pressure (High).
Check that the fuel pressure fluctuates when the target fuel pressure changes.
HINT:

The target fuel pressure operation decreases the target fuel pressure by 12.5% or increases the target fuel pressure by 24.8%.

If the result is not as specified, replace the fuel pump assembly or fuel delivery pipe with sensor assembly LH (fuel pressure sensor).

Check operating sound.
1. Remove the front wiper motor and link assembly.
  Refer to REMOVAL [12/2013 - ]
2. Remove the outer cowl top panel sub-assembly.
  Refer to PROCEDURE - Step 4
3. Start the engine.
4. Using a sound scope, check the operating sound of the fuel pump assembly.
  If no sound can be heard, check the fuel pump assembly, wire harness and ECM.
5. Stop the engine.
6. Install the outer cowl top panel sub-assembly.
  Refer to PROCEDURE - Step 10
7. Install the front wiper motor and link assembly.
  Refer to INSTALLATION [12/2013 - ]