LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Fuel System (2GR-FKS) (Service Information) (Except Hybrid)) >> Fuel Pressure Sensor (For High Pressure) >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY LH (FUEL PRESSURE SENSOR) 

    Refer to REMOVAL [11/2016 - ] 

    NOTE:
    • Do not remove the fuel pressure sensor from the fuel delivery pipe with sensor assembly LH.
    • If the fuel pressure sensor is removed, replace the fuel delivery pipe with sensor assembly LH (fuel pressure sensor) with a new one.
  2. REMOVE FUEL PIPE PLUG SUB-ASSEMBLY 
    1. Secure the fuel delivery pipe with sensor assembly LH in a vise between aluminum plates.
      NOTE:

      Do not overtighten the vise.

      GTY669090Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a 5 mm hexagon socket wrench, remove the 2 bolts, gasket and fuel pipe plug sub-assembly from the fuel delivery pipe with sensor assembly LH.
    3. Remove the dust cap sub-assembly from the fuel pipe plug sub-assembly.
    4. Remove the O-ring, No. 1 fuel injector back-up ring, No. 2 fuel injector back-up ring and No. 3 fuel injector back-up ring from the fuel pipe plug sub-assembly.
    5. Remove the fuel delivery pipe with sensor assembly LH from the vise.
scientia non olet · About LEMON Manuals