LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Engine Cooling System (2GR-FKS) (Service Information) (Except Hybrid)) >> Water Pump >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY 

    Refer to REMOVAL [11/2016 - ] 

  2. REMOVE V-RIBBED BELT 

    Refer to REMOVAL [11/2016 - ]

  3. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY 
    1. Remove the bolt and No. 2 idler pulley sub-assembly.
      GTY722079Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE WATER PUMP PULLEY 
    1. Using SST, hold the water pump pulley.
      GTY716502Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09960-10010 
        1. 09962-01000
        2. 09963-00700
    2. Remove the 4 bolts and water pump pulley.

      HINT: 

      There is not enough clearance to completely remove the water pump pulley from the water pump shaft. Remove the water pump pulley together with the engine water pump assembly.

  5. REMOVE ENGINE WATER PUMP ASSEMBLY 
    1. Remove the 15 bolts, engine water pump assembly, water pump pulley and water pump gasket.
      GTY738736Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals