LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Engine Cooling System (2GR-FKS) (Service Information) (Except Hybrid)) >> Radiator >> Installation [11/2016 - ] >> Procedure

Installation [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL RADIATOR ASSEMBLY 
    1. Engage the 3 guides.
    2. Engage the 3 claws to install the fan shroud assembly to the radiator assembly.
      NOTE:

      Do not damage the radiator assembly when installing the fan shroud assembly.

    3. Install the 2 radiator supports to the radiator assembly.
    4. Install the 2 lower radiator supports to the vehicle body.
    5. Install the radiator assembly with the fan shroud assembly to the 2 lower radiator supports.
  2. CONNECT RADIATOR RESERVE TANK HOSE 

    See step  6

  3. CONNECT NO. 2 RADIATOR HOSE 
    1. Connect the No. 2 radiator hose and slide the clip to secure it.
  4. CONNECT NO. 1 RADIATOR HOSE 

    See step  7

  5. INSTALL COOLER CONDENSER ASSEMBLY 

    Refer to INSTALLATION [11/2016 - ]

  6. ADD ENGINE COOLANT 

    See step  2

  7. INSPECT FOR COOLANT LEAK 

    Refer to PROCEDURE - Step 1

  8. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 103

scientia non olet · About LEMON Manuals