LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Engine Cooling System (2GR-FKS) (Service Information) (Except Hybrid)) >> Cooling Fan Motor >> On-Vehicle Inspection [11/2016 - ] >> Procedure

On-Vehicle Inspection [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT COOLING FAN MOTOR LH 
    1. Disconnect the cooling fan motor LH connector.
    2. Check that the cooling fan motor LH operates smoothly when the battery is connected to the cooling fan motor LH connector.
      GTY449091Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (No. 2 Cooling Fan Motor)
    3. Measure the current while the cooling fan motor LH is operating.

      Standard Current

      Condition Specified Condition
      Battery voltage applied at 20°C (68°F) 11.5 to 17.5 A

      If the result is not as specified, replace the cooling fan motor LH.

    4. Connect the cooling fan motor LH connector.
  2. INSPECT COOLING FAN MOTOR RH 
    1. Disconnect the cooling fan motor RH connector.
    2. Check that the cooling fan motor RH operates smoothly when the battery is connected to the cooling fan motor RH connector.
      GTY440112Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Cooling Fan Motor)
    3. Measure the current while the cooling fan motor RH is operating.

      Standard Current

      Condition Specified Condition
      Battery voltage applied at 20°C (68°F) 11.5 to 17.5 A

      If the result is not as specified, replace the cooling fan motor RH.

    4. Connect the cooling fan motor RH connector.
scientia non olet · About LEMON Manuals