LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Stop And Start System - Cancel Switch Assembly (Service Information) (Except Hybrid)) >> Stop And Start System Cancel Switch Assembly >> Installation [11/2016 - ] >> Procedure

Installation [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ECO RUN CANCEL SWITCH ASSEMBLY 
    1. Engage the 2 claws to install the eco run cancel switch assembly.
  2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 32

  3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 33

  4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 34

  5. INSTALL INSTRUMENT PANEL FINISH PANEL END LH 

    Refer to PROCEDURE - Step 35

  6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH 

    Refer to PROCEDURE - Step 53

  7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 54

  8. INSTALL FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 55

scientia non olet · About LEMON Manuals