LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Stop And Start System - Cancel Switch Assembly (Service Information) (Except Hybrid)) >> Stop And Start System Cancel Switch Assembly >> Inspection [11/2016 - ] >> Procedure

Inspection [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT ECO RUN CANCEL SWITCH ASSEMBLY 
    1. Measure the resistance according to the value(s) in the table below.
      GTY736584Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Eco Run Cancel Switch Assembly)

      Standard Resistance

      Tester Connection Switch Condition Specified Condition
      8 (ECU) - 5 (E) Pushed Below 1 Ω
      Not pushed 10 kΩ or higher

      If the result is not as specified, replace the eco run cancel switch assembly.

    2. Apply battery voltage between the terminals of the switch, and check the illumination condition of the eco run cancel switch assembly.

      OK

      Measurement Condition Specified Condition
      Battery positive (+) → 7 (ILL+)
      Battery negative (-) → 6 (ILL-)      		 Illuminates

      If the result is not as specified, replace the eco run cancel switch assembly.

      GTY712347Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Eco Run Cancel Switch Assembly)
scientia non olet · About LEMON Manuals