LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Battery / Charging System (2GR-FKS) (Service Information) (Except Hybrid)) >> Generator >> Installation [11/2016 - ] >> Procedure

Installation [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL GENERATOR ASSEMBLY 
    1. Install the wire harness clamp bracket with the bolt.

      Torque: 8.4 N*m (86 kgf*cm, 74 in.*lbf) 

    2. Type A:
      1. Install the generator assembly with the 2 bolts.

        Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf) 

      2. Temporarily install the generator assembly bracket with the 2 bolts.
      3. Fully tighten the 2 bolts.

        Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

    3. Type B:
      1. Install the generator assembly bracket to the generator assembly with the bolt.

        Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

        GTY691470Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Install the generator assembly with the 2 bolts.

        Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf) 

      3. Install the nut.

        Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

    4. Engage the 2 wire harness clamps.
    5. Connect the magnetic clutch connector.
    6. Connect the generator assembly connector.
    7. Connect the wire harness to terminal B with the nut.

      Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf) 

    8. Close the terminal cap.
  2. INSTALL V-RIBBED BELT 

    Refer to INSTALLATION [11/2016 - ]

  3. INSTALL FAN SHROUD 

    Refer to INSTALLATION [11/2016 - ]

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [11/2016 - ]

scientia non olet · About LEMON Manuals