Removal [11/2016 - ]: Procedure
WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- PRECAUTION NOTE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [11/2016 - ]
- REMOVE BATTERY STATE SENSOR ASSEMBLY
- Remove the nut and disconnect the engine wire from the battery state sensor assembly.NOTE:
When disconnecting the engine wire, some systems need to be initialized after the engine wire is reconnected.
Refer to INITIALIZATION [11/2016 - ]
- Loosen the nut and remove the battery state sensor assembly from the battery.
- Disconnect the battery state sensor assembly connector.
- Disengage the 2 claws to remove the battery state sensor assembly from the battery current sensor holder.
- Remove the nut and disconnect the engine wire from the battery state sensor assembly.