Installation [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL BATTERY STATE SENSOR ASSEMBLY
1. Engage the 2 claws to install the battery state sensor assembly to the battery current sensor holder.
2. Connect the battery state sensor assembly connector.
3. Install the battery state sensor assembly to the battery and tighten the nut.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
4. Connect the engine wire to the battery state sensor assembly with the nut.
  Torque: 7.6 N*m (77 kgf*cm, 67 in.*lbf)
  
  NOTE:
  When disconnecting the engine wire, some systems need to be initialized after the engine wire is reconnected.
  
  Refer to INITIALIZATION [11/2016 - ]