LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Stop And Start - Diagnostic Codes - (Except Hybrid)) >> Stop And Start System >> DTC P2796-14: Electromagnetic Oil Pump Circuit Open [11/2016 - ] >> Description

DTC P2796-14: Electromagnetic Oil Pump Circuit Open [11/2016 - ]: Description

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

Refer to DTC P279612.

Refer to DESCRIPTION 

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory Note
P279614 Electromagnetic Oil Pump Circuit Open Both of the following conditions are met for 0.16 seconds or more (1 trip detection logic):
  • During oil pump with solenoid assembly preliminary check: First time vehicle speed reaches 2 km/h (1.2 mph) or higher once per driving cycle (Tr1: On, Tr2: Off).
  • EGND terminal voltage below 1 V.
  • Wire harness or connector
  • Transmission wire
  • Oil pump with solenoid assembly
  • Engine stop and start ECU
Blinks DTC stored SAE Code: P2798