LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Control System (2GR-FKS) (Service Information) (Except Hybrid)) >> Throttle Body >> On-Vehicle Inspection [11/2016 - ] >> Procedure

On-Vehicle Inspection [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY 
    1. Check the idle speed.
      1. Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range with the A/C switch off.

        Standard Idle Speed

        650 to 750 rpm

        NOTE:
        • Be sure to perform this step with all accessories off.
        • Make sure that the shift lever is in P or N.
      2. Perform a road test and confirm that there are no abnormalities.
    2. Inspect the throttle position sensor.
      1. Connect the Techstream to the DLC3.
      2. Start the engine.
      3. Turn the Techstream on.
      4. Enter the following menus: Powertrain / Engine / Data List / Throttle Position Sensor No. 1 Voltage %.

        Powertrain > Engine > Data List 

        Tester Display
        Throttle Position Sensor No. 1 Voltage %
      5. Fully depress the accelerator pedal and check that the value is 60% or higher.

        If the percentage is less than 60%, check the throttle body assembly, wire harness and ECM.

scientia non olet · About LEMON Manuals