On-Vehicle Inspection [11/2016 - ]: Procedure

HINT: 

Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.

Refer to INITIALIZATION [11/2016 - ]

1. Read the value of Data List item "Mass Air Flow Sensor" using the Techstream.
   NOTE:

   • Perform the inspection with the vehicle indoors and on a level surface.
   • Perform the inspection of the mass air flow meter sub-assembly while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).
   1. Connect the Techstream to the DLC3.
   2. Turn the ignition switch to ON.
   3. Turn the Techstream on.
   4. Start the engine and warm it up until the engine coolant temperature 75°C (167°F) or higher with all the accessories switched off.
   5. Enter the following menus: Powertrain / Engine / Data List / Mass Air Flow Sensor.

      Powertrain > Engine > Data List 

      Tester Display
      Mass Air Flow Sensor

   6. According to the display on the Techstream, read the Data List when the engine is running.

      Standard Condition

      Techstream Display	Condition	Specified Condition
      Mass Air Flow Sensor	Idling (engine warmed up)	2.0 to 5.0 gm/sec
      	2000 rpm (without load)	18.0 to 22.0 gm/sec
      	3000 rpm (without load)	28.0 to 34.0 gm/sec

      If the result is not as specified, replace the mass air flow meter sub-assembly.

      If the result is within the specified range, remove and inspect the mass air flow meter sub-assembly.

      Refer to INSPECTION [11/2016 - ] 

1. Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.

   Refer to INITIALIZATION [11/2016 - ]