LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Control System (2GR-FKS) (Service Information) (Except Hybrid)) >> HEATED OXYGEN SENSOR (for Bank 2) >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT FLOOR COVER LH 

    Refer to PROCEDURE - Step 3

  2. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 8

  3. REMOVE NO. 2 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 9

  4. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 4

  5. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Lower Side) 

    Refer to PROCEDURE - Step 9

  6. REMOVE FRONT EXHAUST PIPE ASSEMBLY 

    Refer to PROCEDURE - Step 10

  7. REMOVE HEATED OXYGEN SENSOR 
    1. Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.
      GTY613516Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09224-00012 
      NOTE:

      If the heated oxygen sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals