LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Control System (2GR-FKS) (Service Information) (Except Hybrid)) >> HEATED OXYGEN SENSOR (for Bank 1) >> Inspection [11/2016 - ] >> Procedure

Inspection [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT HEATED OXYGEN SENSOR 
    1. Measure the resistance according to the value(s) in the table below.
      GTY649727Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Heated Oxygen Sensor)

      Standard Resistance

      Tester Connection Condition Specified Condition
      2 (HT1B) - 1 (+B) 20°C (68°F) 5 to 10 Ω
      2 (HT1B) - 3 (E2) Always 10 kΩ or higher

      If the result is not as specified, replace the heated oxygen sensor.

scientia non olet · About LEMON Manuals