LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Control System (2GR-FKS) (Service Information) (Except Hybrid)) >> Engine Coolant Temperature Sensor >> Installation [11/2016 - ] >> Procedure

Installation [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR 

    HINT: 

    Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

    Refer to INITIALIZATION [11/2016 - ]

    1. Apply a light coat of engine coolant to the O-ring of the engine coolant temperature sensor.
      NOTE:

      If reusing the engine coolant temperature sensor, be sure to inspect the O-ring.

    2. Install the engine coolant temperature sensor to the water outlet with the clip.
      NOTE:
      • If the engine coolant temperature sensor has been struck or dropped, replace it.
      • Make sure that the O-ring is not cracked or moved out of place when installing the engine coolant temperature sensor.
    3. Connect the engine coolant temperature sensor connector.
  2. ADD ENGINE COOLANT 

    Refer to PROCEDURE - Step 2

  3. INSPECT FOR COOLANT LEAK 

    Refer to PROCEDURE - Step 1

  4. INSTALL V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 91

  5. PERFORM INITIALIZATION 
    1. Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

      Refer to INITIALIZATION [11/2016 - ]

scientia non olet · About LEMON Manuals