Installation [11/2016 - ]: Procedure
WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL NO. 2 ECM BRACKET
- Install the No. 2 ECM bracket to the ECM with the 2 screws.
Torque: 4.5 N*m (46 kgf*cm, 40 in.*lbf)
- Install the No. 2 ECM bracket to the ECM with the 2 screws.
- INSTALL ECM BRACKET
- Install the ECM bracket to the ECM with the 2 screws.
Torque: 4.5 N*m (46 kgf*cm, 40 in.*lbf)
- Install the ECM bracket to the ECM with the 2 screws.
- INSTALL ECM
- Install the ECM with the 3 bolts.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
NOTE:If the ECM has been struck or dropped, replace it.
- Engage the clamp to install the wire harness.
- Connect the 2 ECM connectors and lower the 2 levers.NOTE:
- When connecting the ECM connectors, make sure that the connecting parts of the ECM connectors are free of dirt, water or other foreign matter.
- Be sure to securely connect the ECM connectors.
- Install the ECM with the 3 bolts.
- INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
Refer to PROCEDURE - Step 62
- INSTALL INLET AIR CLEANER ASSEMBLY
Refer to PROCEDURE - Step 63
- INSTALL COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 4
- INSTALL RADIATOR SIDE SEAL RH
Refer to PROCEDURE - Step 5
- INSTALL RADIATOR SIDE DEFLECTOR SEAL LH
Refer to PROCEDURE - Step 6
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [11/2016 - ]
- PERFORM INITIALIZATION
Refer to PRECAUTION [11/2016 - ]