LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Control System (2GR-FKS) (Service Information) (Except Hybrid)) >> Accelerator Pedal >> On-Vehicle Inspection [11/2016 - ] >> Procedure

On-Vehicle Inspection [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine / Data List / Accelerator Position Sensor No. 1 Voltage and Accelerator Position Sensor No. 2 Voltage.

      Powertrain > Engine > Data List 

      Tester Display
      Accelerator Position Sensor No. 1 Voltage
      Accelerator Position Sensor No. 2 Voltage
    5. Read the values displayed on the Techstream.

      Standard Voltage

      Tester Display Condition Specified Condition
      Accelerator Position Sensor No. 1 Voltage Accelerator pedal fully released 0.5 to 1.1 V
      Accelerator pedal fully depressed 2.6 to 4.5 V
      Accelerator Position Sensor No. 2 Voltage Accelerator pedal fully released 1.2 to 2.0 V
      Accelerator pedal fully depressed 3.4 to 4.75 V

      If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.

scientia non olet · About LEMON Manuals