LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Emission Control System (2GR-FKS) (Service Information) (Except Hybrid)) >> Purge Valve >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 25

  2. REMOVE PURGE VALVE (PURGE VSV) 
    1. Disconnect the purge valve (purge VSV) connector.
      GTY703992Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 No. 1 Fuel Vapor Feed Hose
      *2 Fuel Vapor Feed Hose
    2. Slide the clip and disconnect the fuel vapor feed hose from the purge valve (purge VSV).
    3. Disconnect the No. 1 fuel vapor feed hose from the purge valve (purge VSV).
    4. Remove the bolt and purge valve (purge VSV) from the intake air surge tank assembly.
scientia non olet · About LEMON Manuals