Installation [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY)
1. Apply a light coat of engine oil to the O-ring.
2. Using a 22 mm deep socket wrench, install the PCV valve (ventilation valve sub-assembly) to the cylinder head cover sub-assembly LH.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  NOTE:
  When reusing the PCV valve (ventilation valve sub-assembly), inspect the O-ring.
CONNECT VENTILATION HOSE
1. Connect the ventilation hose to the PCV valve (ventilation valve sub-assembly) and slide the clip to secure it.
INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 91