LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine Mechanical (2GR-FKS) (Service Information) (Except Hybrid)) >> Front Crankshaft Oil Seal >> Installation [11/2016 - ] >> Procedure

Installation [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL TIMING CHAIN CASE OIL SEAL 
    1. Apply MP grease to the lip of a new timing chain case oil seal.
      GTY673864Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Oil Seal Protrusion Height
    2. Using SST and a hammer, tap in the timing chain case oil seal until its surface is flush with the timing chain cover assembly edge.
      • SST: 09316-60011 
        1. 09316-00011

      Oil Seal Protrusion Height

      0 to 1.0 mm (0 to 0.0394 in.)

      NOTE:
      • Keep the lip free from foreign matter.
      • Do not tap in the timing chain case oil seal at an angle.
  2. INSTALL CRANKSHAFT PULLEY 
    1. Align the pulley set key with the key groove of the crankshaft pulley.
    2. Using SST to hold the crankshaft pulley in place, tighten the crankshaft pulley set bolt.
      GTY678152Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Hold
      Turn
      • SST: 09213-70011 
        1. 09213-70020
      • SST: 09330-00021 

      Torque: 260 N*m (2651 kgf*cm, 192 ft.*lbf) 

  3. INSTALL V-RIBBED BELT 

    Refer to INSTALLATION [11/2016 - ] 

  4. INSPECT FOR ENGINE OIL LEAK 

    Refer to PROCEDURE - Step 5

scientia non olet · About LEMON Manuals