LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine Mechanical (2GR-FKS) (Service Information) (Except Hybrid)) >> Drive Belt >> On-Vehicle Inspection [11/2016 - ] >> Procedure

On-Vehicle Inspection [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT V-RIBBED BELT 
    1. Check the V-ribbed belt for wear, cracks or other signs of damage.
      GTY377881Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      If any of the following defects is found, replace the V-ribbed belt.

      • The V-ribbed belt is cracked.
      • The V-ribbed belt is worn to the extent that the cords are exposed.
      • The V-ribbed belt has chunks missing from the ribs.
    2. Check that the V-ribbed belt fits properly in the ribbed grooves.
      GTY452814Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Correct
      *b Incorrect

      HINT: 

      Make sure to check by hand that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the V-ribbed belt. Install a new V-ribbed belt correctly.

scientia non olet · About LEMON Manuals