LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Stop And Start (Service Information) (Except Hybrid)) >> Engine Stop And Start Ecu >> Installation [11/2016 - ] >> Procedure

Installation [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ENGINE STOP AND START ECU 
    1. Install the engine stop and start ECU with the bolt and nut.

      Bolt 

      Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf) 

      Nut 

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

    2. Connect the 3 engine stop and start ECU connectors.
    3. Engage the clamp.
    4. Connect each connector.
  2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 32

  3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 33

  4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 34

  5. INSTALL INSTRUMENT PANEL FINISH PANEL END LH 

    Refer to PROCEDURE - Step 35

  6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH 

    Refer to PROCEDURE - Step 53

  7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 54

  8. INSTALL FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 55

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [11/2016 - ]

  10. PERFORM REGISTRATION 

    Refer to REGISTRATION [11/2016 - ]

scientia non olet · About LEMON Manuals